TP-Link T2500G-10TS - Spanning-Tree Mcheck

removing MAC address entries, which may decrease the performance and
stability of the network. With the Protect of Spanning Tree function enabled,
you can configure the number of TC-BPDUs in a required time, so as to avoid
the process of removing MAC addresses frequently.
Syntax
spanning-tree guard tc
no spanning-tree guard tc
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the TC Protect of Spanning Tree for port 2:
T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# spanning-tree guard tc
29.21 spanning-tree mcheck
Description
The spanning-tree mcheck command is used to enable mcheck.
Syntax
spanning-tree mcheck
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable mcheck for port 2:
T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# spanning-tree mcheck
239