TP-Link T2500G-10TS - Logon by Telnet

5. The DOS prompt ”T2500G-10TS>” will appear after pressing the Enter button as shown in
Figure 1-1. It indicates that you can use the CLI now.
Figure 1-2 Log in the Switch
1.1.2 Logon by Telnet
Telnet login has the following two modes. You can choose one according to your needs:
Login local Mode: It requires username and password, which are both admin by default.
Login Mode: It doesn’t require username and password, but a connection password is
required.
 Login Local Mode
Firstly, configure the Telnet login mode as “login local” in the prompted DOS screen shown in
Figure 1-2.
Figure 1-3 Configure login local mode
6