Logon
Take the following steps to log on to the switch by the console port.
1. Connect the PCs or Terminals to the console port on the switch by the provided cable.
2. Start the terminal emulation program (such as the HyperTerminal) on the PC.
3. Specify the connection COM port in the terminal emulation program. If the Micro-USB
Console port is used, you can view which port is assigned to the USB serial port in the
following path:
Control Panel -> Hardware and Sound -> Device Manager -> Ports ->USB Serial Port.
Figure 1-1 USB Serial Port Number
4. Configure the terminal emulation program or the terminal to use the following settings:
Baud rate: 38400 bps
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
5
To Next Page
Loading...
