Parameter
num
—— The maximum number of the connections to the SSH server. It
ranges from 1 to 5. By default, this value is 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the maximum number of the connections to the SSH server as 3:
T2500G-10TS(config)# ip ssh max-client 3
19.6 ip ssh download
Description
The ip ssh download command is used to download the SSH key file from
TFTP server.
Syntax
ip ssh download { v1 | v2 }
key-file
ip-address
ip-addr
Parameter
v1 | v2 —— Select the type of SSH key to download, v1 represents SSH-1,
v2 represents SSH-2.
key-file
—— The name of the key-file which is selected to download. The
length of the name ranges from 1 to 25 characters. The key length of the
downloaded file must be in the range of 512 to 3072 bits.
ip-addr
—— The IP address of the TFTP server. Both IPv4 and IPv6 addresses
are supported, for example 192.168.0.1 or fe80::1234.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
142
To Next Page
Loading...
