TP-Link T2500G-10TS - Show Dot1 Q-Tunnel

Parameter
uni ——The port connected to the clients.
nni ——The port connected to the ISP.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Gigabit Ethernet port 1/0/3 as the VPN UNI ports:
T2500G-10TS(config)#interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)#switchport dot1q-tunnel mode uni
6.7 show dot1q-tunnel
Description
The show dot1q-tunnel command is used to display the global configuration
information of the VLAN VPN.
Syntax
show dot1q-tunnel
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the global configuration information of the VLAN VPN:
T2500G-10TS(config)#show dot1q-tunnel
48