TP-Link T2500G-10TS - Snmp-Server Traps Mac

storm-control —— Enable storm-control trap. It is sent when the multicast or
broadcast rate exceeds the predefined value.
spanning-tree —— Enable spanning-tree trap. It is sent when the port
forwarding status changes or the port receives TCN packet or packet with TC
fport-channel-.
memory —— Enable memory trap. It is sent when memory usage exceeds
80%.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable SNMP extended bandwidth-control trap for the switch:
T2500G-10TS(config)# snmp-server traps bandwidth-control
33.11 snmp-server traps mac
Description
The snmp-server traps mac command is used to enable SNMP extended
MAC address-related traps which include four types: new, full,
learn-mode-change and max-learned. To disable the sending of SNMP
extended MAC address related traps, please use no snmp-server traps mac
command.
Syntax
snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
no snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
Parameter
new —— Enable new MAC address trap. It is sent when the switch learns new
MAC address including dynamic address, static address and filter address.
full —— Enable MAC address table trap. It is sent when the MAC address
table is full.
learn-mode-change —— Enable MAC address learn-mode-change trap. It is
sent when MAC address learning mode of the switch changes.
298