TP-Link T2500G-10TS - Chapter 15 Maintenance; 15.1 System Monitor

29.24 show spanning-tree interface
Description
The show spanning-tree interface command is used to display the
spanning-tree information of all ports or a specified port.
Syntax
show spanning-tree interface [ gigabitEthernet port ] [ edge | ext-cost |
int-cost | mode | p2p | priority | role | state | status ]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the spanning-tree information of all ports:
T2500G-10TS(config)# show spanning-tree interface
Display the spanning-tree information of port 1/0/2:
T2500G-10TS(config)# show spanning-tree interface gigabitEthernet
1/0/2
Display the spanning-tree mode information of port 1/0/2:
T2500G-10TS(config)# show spanning-tree interface gigabitEthernet
1/0/2 mode
29.25 show spanning-tree interface-security
Description
The show spanning-tree interface-security command is used to display the
protect information of all ports or a specified port.
Syntax
show spanning-tree interface-security [ gigabitEthernet port ] [ bpdufilter |
bpduguard | loop | root | tc | tc-defend ]
241