TP-Link T2500G-10TS - Ip Dhcp Relay Information Remote-ID

Parameter
circuitID —— Specify the circuit ID, ranging from 1 to 63 characters.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the circuit ID as “TP-Link”:
T2500G-10TS(config)# ip dhcp relay information circuit-id TP-Link
36.6 ip dhcp relay information remote-id
Description
The ip dhcp relay information remote-id command is used to specify the
custom remote ID when option 82 customization is enabled. To clear the
remote ID, please use no ip dhcp relay information remote-id command.
Syntax
ip dhcp relay information remote-id remoteID
no ip dhcp relay information remote-id
Parameter
remoteID —— Specify the remote ID, ranging from 1 to 63 characters.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the remote ID as “TP-Link”:
T2500G-10TS(config)# ip dhcp relay information remote-id TP-Link
347