TP-Link T2500G-10TS - Enable Authentication(Ssh); Ip Http Login Authentication

35.25 enable authentication(ssh)
Description
The enable authentication command is used to apply the privilege
authentication method list to the ssh terminal line. To restore to the default
authentication method list, please use the no enable authentication
command.
Syntax
enable authentication { method-list }
no enable authentication
Parameter
method-list —— Specify the enable method list on the ssh terminal line. It is
“default” by default, which contains the method “none”.
Command Mode
Line Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the enable authentication method list on the ssh terminal line as
“list2”:
T2500G-10TS(config)# line ssh
T2500G-10TS(config-line)# enable authentication list2
35.26 ip http login authentication
Description
The ip http login authentication command is used to apply the login
authentication method list to users accessing through HTTP. To restore to
the default authentication method list, please use the no ip http login
authentication command.
Syntax
ip http login authentication { method-list }
341