TP-Link T2500G-10TS - Show Snmp-Server

Syntax
rmon statistics index interface gigabitEthernet port [ owner owner-name ]
[ status { underCreation | valid }]
no rmon statistics
index
Parameter
index —— The index number of the statistics entry, ranging from 1 to 65535,
in the format of 1-3,5.
port —— The statistics port number, in the format of 1/0/1.
owner-name
—— The creator of the event entry, ranging from 1 to 16
characters. By default, it is “monitor”.
status —— The status of the statistics entry, either “underCreation” or
“valid”. “underCreation” means this entry won’t take effect until it is modified
to “valid”; “valid” means this entry takes effect immediately after it is created.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the statistics entries 1-3 with the statistics port as 1/0/1, owner as
owner1 and status as valid:
T2500G-10TS(config)#rmon statistics 1-3 interface gigabitEthernet 1/0/1
owner owner1 status valid
33.17 show snmp-server
Description
The show snmp-server command is used to display SNMP configuration
globally.
Syntax
show snmp-server
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
304