TP-Link T2500G-10TS - Show System-Info; Show Boot

Test the connectivity between the switch and the network device with the IP
fe80::1234. If the destination device has not been found after 20
maxHops ,
the connection between the switch and the destination device is failed to
establish:
T2500G-10TS# tracert fe80::1234 20
21.19 show system-info
Description
The show system-info command is used to display System Description,
Device Name, Device Location, System Contact, Hardware Version, Firmware
Version, System Time, Run Time and so on.
Syntax
show system-info
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the system information:
T2500G-10TS# show system-info
21.20 show boot
Description
The show boot command is used to display the boot configuration of the
system.
Syntax
show boot
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
167