TP-Link T2500G-10TS - Switchport Mode

Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the name of VLAN 2 as “group1”:
T2500G-10TS(config)# vlan 2
T2500G-10TS(config-vlan)# name group1
3.4 switchport mode
Description
The switchport mode command is used to configure the Link Types for the
ports.
Syntax
switchport mode { access | trunk | general }
Parameter
access | trunk | general —— Link Types. There are three Link Types for the
ports.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the Link Type of Gigabit Ethernet port 1/0/3 as “trunk”:
T2500G-10TS(config)#interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)#switchport mode trunk
30