TP-Link T2500G-10TS - Show Interface Configuration; Show Storm-Control

23.13 show interface configuration
Description
The show interface configuration command is used to display the
configurations of all ports, including Port-status, Flow Control, Negotiation
Mode and Port-description.
Syntax
show interface configuration
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configurations of all Ethernet ports:
T2500G-10TS(config)# show interface configuration
23.14 show storm-control
Description
The show storm-control command is used to display the storm-control
information of Ethernet ports.
Syntax
show storm-control [ interface gigabitEthernet port-list ]
Parameter
port-list ——The list of Ethernet ports.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the storm-control information of port 4, 5, 6, and 7:
T2500G-10TS(config)# show storm-control interface gigabitEthernet
1/0/4-7
187