TP-Link T2500G-10TS - Lldp Transmit; Lldp Snmp-Trap

34.5 lldp transmit
Description
The lldp transmit command is used to enable the designated port to transmit
LLDPDU. To disable the function, please use no lldp transmit command.
Syntax
lldp transmit
no lldp transmit
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable Gigabit Ethernet port 1/0/1 to transmit LLDPDU:
T2500G-10TS(config)# interface gigabitEthernet 1/0/1
T2500G-10TS(config-if)#lldp transmit
34.6 lldp snmp-trap
Description
The lldp snmp-trap command is used to enable the port’s SNMP notification.
If enabled, the port will notify the trap event to network management system.
To disable the ports' SNMP notification, please use no lldp snmp-trap
command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
314