TP-Link T2500G-10TS - Dldp Reset(Interface); Show Dldp

T2500G-10TS (config-if-range)# dldp
30.6 dldp reset(interface)
Description
The dldp reset command is used to reset the specified port and restart the
link detect process.
Syntax
dldp reset
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Reset the DLDP function of ports 2-4:
T2500G-10TS (config)# interface range gigabitEthernet 1/0/2-4
T2500G-10TS (config-if-range)# dldp reset
30.7 show dldp
Description
The show dldp command is used to display the global configuration of DLDP
function such as DLDP global state, DLDP interval and shut mode.
Syntax
show dldp
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
247