TP-Link T2500G-10TS - Ipv6 Mld Snooping Max-Group; Clear Ipv6 Mld Snooping Statistics

T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# ipv6 mld snooping filter-id 1,10
32.24 ipv6 mld snooping max-group
Description
The ipv6 mld snooping max-group command is used to specify the limit
number of groups for a port to join in. The default value is 256. To restore the
default value, please use no ipv6 mld snooping max-group command.
Syntax
ipv6 mld snooping max-group limit
no ipv6 mld snooping max-group
Parameter
limit —— Specify the max number of multicast groups on a port, ranging from
0 to 256.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the limit group as 128 on interface gigabitEthernet 1/0/2:
T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# ipv6 mld snooping max-group 128
32.25 clear ipv6 mld snooping statistics
Description
The clear ipv6 mld snooping statistics command is used to clear the
statistics of the MLD packets.
Syntax
clear ipv6 mld snooping statistics
282