Parameter
name
—— The entry name of View, ranging from 1 to 16 characters. Each
View includes several entries with the same name.
mib-oid
—— MIB Object ID. It is the Object Identifier (OID) for the entry of
View, ranging from 1 to 61 characters.
include | exclude —— View Type, with include and exclude options. They
represent the view entry can/cannot be managed by the SNMP management
station individually.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Add a View named view1, configuring the OID as 1.3.6.1.6.3.20, and this OID
can be managed by the SNMP management station:
T2500G-10TS(config)# snmp-server view view1 1.3.6.1.6.3.20 include
33.3 snmp-server group
Description
The snmp-server group command is used to manage and configure the
SNMP group. To delete the corresponding SNMP group, please use no
snmp-server group command. SNMP v3 provides the VACM (View-based
Access Control Model) and USM (User-Based Security Model) mechanisms
for authentication. The users in the SNMP Group can manage the device via
the Read View, Write View and Notify View. And the authentication mode and
the privacy mode guarantee the high security for the communication
between the management station and the managed device.
Syntax
snmp-server group
name
[ smode { v1 | v2c | v3 }] [ slev { noAuthNoPriv |
authNoPriv | authPriv }] [ read
read-view
] [ write
write-view
] [ notify
notify-view
]
no snmp-server group
name
smode { v1 | v2c | v3 } slev { noAuthNoPriv |
authNoPriv | authPriv }
289
To Next Page
Loading...
