TP-Link T2500G-10TS - Tacacas-Server Host

Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
User Guidelines
If both the enable admin password and enable admin secret are defined,
you must enter the password set in enable admin secret.
Example
Set the secret elevation password as 123 for the current logged-in user to
gain administrator level privileges. The password will be displayed in the
encrypted form:
T2500G-10TS(config)#enable admin secret 0 123
35.4 tacacas-server host
Description
The tacacs-server host command is used to configure a new TACACS+
server. To delete the specified TACACS+ server, please use no
tacacs-server host command.
Syntax
tacacs-server host ip-address [ port port-id ] [ timeout time ] [ key { [ 0 ]
string
| 7 encryped-string } ]
no tacacs-server host
ip-address
Parameter
ip-address —— Specify the IP address of the TACACS+ server.
port-id
—— Specify the server’s port number for AAA. By default it is 49.
time —— Specify the time in seconds the switch waits for the server’s
response before it times out. The time ranges from 1 to 9 seconds. The
default is 5 seconds.
[ 0 ]
string | 7 encrypted-string —— 0 and 7 are the encryption type. 0
indicates that an unencrypted key will follow. 7 indicates that a symmetric
encrypted key with a fixed length will follow. By default, the encryption type is
325