TP-Link T2500G-10TS - Access-List Policy Name

source-mac —— The source MAC address contained in the rule.
source-mac-mask —— The source MAC address mask. It is required if you
typed the source MAC address.
destination-mac —— The destination MAC address contained in the rule.
destination-mac-mask —— The destination MAC address mask. It is required
if you typed the destination MAC address.
vlan-id —— The VLAN ID contained in the rule, ranging from 1 to 4094.
ethernet-type —— EtherType contained in the rule, in the format of 4-hex
number.
user-pri —— The user priority contained in the rule, ranging from 0 to 7. By
default, it is not limited.
time-segment —— The time-range for the rule to take effect. By default, it is
not limited.
Command Mode
MAC Access-list Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create a MAC ACL whose ID is 20, and add Rule 10 for it. In the rule, the
source MAC address is 00:01:3F:48:16:23, the source MAC address mask is
11:11:11:11:11:00, VLAN ID is 2, the user priority is 5, the time-range for the
rule to take effect is “tRange1”, and the packets match this rule will be
forwarded by the switch:
T2500G-10TS(config)# mac access-list 20
T2500G-10TS(config-mac-acl)# rule 10 permit smac 00:01:3F:48:16:23
smask 11:11:11:11:11:00 vid 2 pri 5 tseg tRange1
28.11 access-list policy name
Description
The access-list policy name command is used to add Policy. To delete the
corresponding Policy, please use no access-list policy name command. A
Policy is used to control the data packets those match the corresponding
ACL rules by configuring ACLs and actions together for effect. The
216