TP-Link T2500G-10TS - Show Ip Dos-Prevent

Syntax
ip dos-prevent type { land | scan-synfin | xma-scan | null-scan |
port-less-1024 | blat | ping-flood | syn-flood }
no ip dos-prevent type { land | scan-synfin | xma-scan | null-scan |
port-less-1024 | blat | ping-flood | syn-flood }
Parameter
land —— Land attack.
scan-synfin —— Scan SYNFIN attack.
xma-scan —— Xma Scan attack.
null-scan —— NULL Scan attack.
port-less-1024 ——The SYN packets whose Source Port less than 1024.
blat —— Blat attack.
ping-flood —— Ping flooding attack. With the ping flood attack enabled, the
switch will limit automatically the forwarding speed of ping packets to 512K
when attacked by ping flood.
syn-flood —— SYN/SYN-ACK flooding attack. With the syn-flood attack
enabled, the switch will limit automatically the forwarding speed of ping
packets to 512K when attacked by syn-flood.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the DoS Defend Type named Land attack:
T2500G-10TS(config)#ip dos-prevent type land
15.3 show ip dos-prevent
Description
The show ip dos-prevent command is used to display the DoS information of
the detected DoS attack, including enable/disable status, the DoS Defend
Type,
the count of the attack, etc.
112