TP-Link T2500G-10TS - Pppoe Circuit-ID(Interface); Pppoe Circuit-ID Type

17.2 pppoe circuit-id(interface)
Description
The pppoe circuit-id command is used to enable the PPPoE Circuit-ID
Insertion function for a specified port. To disable the PPPoE Circuit-ID
Insertion function on a specified port, please use no pppoe circuit-id
command.
Syntax
pppoe circuit-id
no pppoe circuit-id
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the PPPoE Circuit-ID Insertion function for the Gigabit Ethernet port
1/0/1:
T2500G-10TS (config)# interface gigabitEthernet 1/0/1
T2500G-10TS (config-if)# pppoe circuit-id
17.3 pppoe circuit-id type
Description
The pppoe circuit-id type command is used to configure the type of PPPoE
Circuit-ID for a specified port. By default, the PPPoE Circuit-ID type is “ip”.
Syntax
pppoe circuit-id type { mac | ip | udf [ Value ] | udf-only [ Value ] }
Parameter
mac | ip | udf | udf-only —— The type of PPPoE Circuit-ID for the port.
mac: The MAC address of the switch will be used to encode the Circuit-ID
option.
128