TP-Link T2500G-10TS - Show Loopback-Detection Global; Show Loopback-Detection Interface

Example
Recover the blocked port 1/0/2 to normal status:
T2500G-10TS(config)# interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)# loopback-detection recover
27.7 show loopback-detection global
Description
The show loopback-detection global command is used to display the global
configuration of loopback detection function such as loopback detection
global status, loopback detection interval and loopback detection recovery
time.
Syntax
show loopback-detection global
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the global configuration of loopback detection function:
T2500G-10TS# show loopback-detection global
27.8 show loopback-detection interface
Description
The show loopback-detection interface command is used to display the
configuration of loopback detection function and the status of the specified
Ethernet port.
Syntax
show loopback-detection interface [ gigabitEthernet port ]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
206