TP-Link T2500G-10TS - Periodic

Syntax
absolute start start-date end end-date
no absolute
Parameter
start-date —— The start date in Absoluteness Mode, in the format of
MM/DD/YYYY. By default, it is 01/01/1970.
end-date —— The end date in Absoluteness Mode, in the format of
MM/DD/YYYY. By default, it is 12/31/2099. The Absoluteness Mode will be
disabled if the start date and end date are both in default value.
Command Mode
Time-range Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the time-range tSeg1 with time from May 5, 2012 to Oct. 5, 2012:
T2500G-10TS(config)# time-range tSeg1
T2500G-10TS(config-time-range)# absolute start 05/05/2012 end
10/05/2012
28.3 periodic
Description
The periodic command is used to configure the time-range into periodic
mode. To delete the corresponding Periodic Mode time-range, please use no
periodic command. To delete the corresponding Periodic Mode week-date
time-range, please use no periodic week-date command. To delete the
corresponding Periodic Mode time-slice time-range, please use no periodic
time-slice command.
Syntax
periodic [week-date week-day ] [time-slice1 time-slice ] [time-slice2
time-slice ] [time-slice3 time-slice ] [time-slice4 time-slice ]
no periodic
no periodic week-date
no periodic time-slice
209