TP-Link T2500G-10TS - Clear Counters

no bandwidth { all | ingress | egress }
Parameter
ingress-rate —— Specify the bandwidth for receiving packets. Range:
1-1000000Kbps for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:
1-1000000Kbps for the gigaport.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for
port 1/0/5:
T2500G-10TS(config)# interface gigabitEthernet 1/0/5
T2500G-10TS(config-if)# bandwidth ingress 5120 egress 1024
23.10 clear counters
Description
The clear counters command is used to clear the statistics information of all
the Ethernet ports.
Syntax
clear counters
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Clear the statistic information of all ports and port channels:
T2500G-10TS(config)# clear counters
185