TP-Link T2500G-10TS - Redirect Interface; S-Condition

Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Add ACL whose ID is 120 to policy1 and create an action for them:
T2500G-10TS(config)# access-list policy action policy1 120
28.13 redirect interface
Description
The redirect interface command is used to configure Direction function of
policy action for specified ports.
Syntax
redirect interface { gigabitEthernet port }
Parameter
port —— The Destination Port of Redirect. The data packets matching the
corresponding ACL will be forwarded to the specific port. By default, it is All
Ports.
Command Mode
Action Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Edit the actions for policy1. Forward the data packets matching ACL 120 in
the policy to Gigabit Ethernet port 2:
T2500G-10TS(config)#access-list policy action policy1 120
T2500G-10TS(config-action)#redirect interface gigabitEthernet 1/0/2
28.14 s-condition
Description
The s-condition command is used to configure Stream Condition function of
policy action.
218