TP-Link T2500G-10TS - Show Access-List; Show Access-List Status

Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Bind policy1 to VLAN 2:
T2500G-10TS(config)# interface vlan 2
T2500G-10TS(config-if)# access-list bind policy1
28.19 show access-list
Description
The show access-list command is used to display configuration of ACL.
Syntax
show access-list acl-id
Parameter
acl-id —— The ID of the ACL selected to display the configuration.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configuration of the MAC ACL whose ID is 20:
T2500G-10TS(config)# show access-list 20
28.20 show access-list status
Description
The show access-list status command is used to display the status of ACL
hardware entry table. Here you can view the total number and available
number of the ACL entries.
Syntax
show access-list status
Command Mode
Privileged EXEC Mode and Any Configuration Mode
222