TP-Link T2500G-10TS - Pppoe Remote-ID

ip: The IP address of the switch will be used to encode the Circuit-ID option.
This is the default value.
udf: A user specified string with the maximum length of 40 characters will be
used to encode the Circuit-ID option.
udf-only: Only the user specified string with the maximum length of 40 will be
used to encode the Circuit-ID option.
Value —— The value of udf/udf-only. The maximum length is 40 characters.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the type of PPPoE Circuit-ID as “mac” for the Gigabit Ethernet port
1/0/1:
T2500G-10TS (config)# interface gigabitEthernet 1/0/1
T2500G-10TS (config-if)# pppoe circuit-id type mac
17.4 pppoe remote-id
Description
The pppoe remote-id command is used to enable the PPPoE Remote-ID
Insertion and configure the Remote-ID value for a specified port. To disable
the PPPoE Remote-ID Insertion function on a specified port, please use no
pppoe remote-id command. By default, the PPPoE Remote-ID Insertion is
disabled.
Syntax
pppoe remote-id [ Value ]
no pppoe remote-id
Parameter
Value —— The value of UDF. The maximum length is 40 characters. If not
specified, the default value will be the PPPoE client’s MAC address.
129