TP-Link T2500G-10TS - Dot1 Q-Tunnel Mapping

Syntax
dot1q-tunnel tpid tpid
no dot1q-tunnel tpid
Parameter
tpid —— The value of Global TPID. It must be 4 Hex integers. By default, it is
8100.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure Global TPID of the VLAN-VPN as 0x9100:
T2500G-10TS(config)#dot1q-tunnel tpid 9100
6.3 dot1q-tunnel mapping
Description
The dot1q-tunnel mapping command is used to enable the VLAN Mapping
feature globally. To disable this function, please use the no dot1q-tunnel
mapping command. By default, the VLAN Mapping feature is disabled.
Syntax
dot1q-tunnel mapping
no dot1q-tunnel mapping
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the VLAN mapping feature globally:
45