TP-Link T2500G-10TS - Switchport Access Vlan; Switchport Trunk Allowed Vlan

3.5 switchport access vlan
Description
The switchport access vlan command is used to add the desired Access
port to IEEE 802.1Q VLAN, or to remove a port from the corresponding VLAN.
Syntax
switchport access vlan vlan-id
no switchport access vlan
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 2 to 4094.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure Gigabit Ethernet port 1/0/3 whose link type is “access” to VLAN 2:
T2500G-10TS(config)#interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)#switchport access vlan 2
3.6 switchport trunk allowed vlan
Description
The switchport trunk allowed vlan command is used to add the desired
Trunk port to IEEE 802.1Q VLAN. To remove a Trunk port from the
corresponding VLAN, please use no switchport trunk allowed vlan
command.
Syntax
switchport trunk allowed vlan { vlan-list }
no switchport trunk allowed vlan { vlan-list }
31