TP-Link T2500G-10TS - Ip Igmp Snooping Querier Vlan (General Query)

Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the IGMP Snooping Querier function of VLAN 1:
T2500G-10TS(config)#ip igmp snooping querier vlan 1
31.14 ip igmp snooping querier vlan (general query)
Description
The ip igmp snooping querier vlan command is used to configure the
parameters for IGMP Snooping Querier to send a general query frame. To
return to the default configuration, please use no ip igmp snooping querier
vlan command.
Syntax
ip igmp snooping querier vlan vlan-id { query-interval interval |
max-response-time
response-time | general-query source-ip ip-addr }
no ip igmp snooping querier vlan
vlan-id { query-interval |
max-response-time
| general-query source-ip }
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
interval —— The time interval to send a general query frame by IGMP
Snooping Querier, ranging from 10 to 300 (Seconds). By default, it is 60
seconds.
response-time —— The maximal time for the host to respond to a general
query frame, ranging from 1 to 25 (Seconds). By default, it is 10 Seconds.
ip-addr —— The source IP of the general query frame sent by IGMP Snooping
Querier. It should not be a multicast IP or a broadcast IP. By default, it is
192.168.0.1.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
259