TP-Link T2500G-10TS - Enable Authentication(Console); Line Telnet

35.19 enable authentication(console)
Description
The enable authentication command is used to apply the privilege
authentication method list to the console port. To restore to the default
authentication method list, please use the no enable authentication
command.
Syntax
enable authentication { method-list }
no enable authentication
Parameter
method-list —— Specify the enable method list on the console port. It is
“default” by default, which contains the method “none”.
Command Mode
Line Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the enable authentication method list on the console port as “list2”:
T2500G-10TS(config)# line console 0
T2500G-10TS(config-line)# enable authentication list2
35.20 line telnet
Description
The line telnet command is used to enter the Line Configuration Mode to
configure the telnet terminal line to which you want to apply the
authentication list.
Syntax
line telnet
337