Preface
This Guide is intended for network administrator to provide referenced information about CLI
(Command Line Interface). The device mentioned in this Guide stands for T2500G-10TS
JetStream 8-Port Gigabit L2 Managed Switch with 2 SFP Slots without any explanation.
Overview of this Guide
Chapter 1: Using the CLI
Provide information about how to use the CLI, CLI Command Modes, Security Levels and some
Conventions.
Chapter 2: User Interface
Provide information about the commands used to switch between five CLI Command Modes.
Chapter 3: IEEE 802.1Q VLAN Commands
Provide information about the commands used for configuring IEEE 802.1Q VLAN.
Chapter 4: MAC-based VLAN Commands
Provide information about the commands used for configuring MAC-based VLAN.
Chapter 5: Protocol-based VLAN Commands
Provide information about the commands used for configuring Protocol VLAN.
Chapter 6: VLAN-VPN Commands
Provide information about the commands used for configuring VLAN-VPN (Virtual Private
Network) function.
Chapter 7: Voice VLAN Commands
Provide information about the commands used for configuring Voice VLAN.
Chapter 8: L2PT Commands
Provide information about the commands used for configuring L2PT (Layer 2 Portocol
Tunneling).
Chapter 9: GVRP Commands
Provide information about the commands used for configuring GVRP (GARP VLAN registration
protocol).
Chapter 10: Etherchannel Commands
Provide information about the commands used for configuring LAG (Link Aggregation Group)
and LACP (Link Aggregation Control Protocol).
Chapter 11: User Management Commands
Provide information about the commands used for user management.
1
To Next Page
Loading...
