TP-Link T2500G-10TS - Contact-Info

Parameter
location —— Device Location. It consists of 32 characters at most. It is
“SHENZHEN” by default.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the system location as SHENZHEN:
T2500G-10TS(config)# location SHENSHEN
21.8 contact-info
Description
The contact-info command is used to configure the system contact
information. To clear the system contact information, please use no
contact-info command.
Syntax
contact-info [ contact_info ]
no contact-info
Parameter
contact_info —— Contact Information. It consists of 32 characters at most. It
is “www.tp-link.com” by default.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the system contact information as www.tp-link.com:
T2500G-10TS(config)# contact
-
info www.tp-link.com
159