TP-Link T2500G-10TS - Protocol-Vlan Group; Show Protocol-Vlan Template

5.3 protocol-vlan group
Description
The protocol-vlan command is used to add the port to a specified protocol
group. To remove the port from this protocol group, please use no
protocol-vlan group command.
Syntax
protocol-vlan group index
no protocol-vlan group index
Parameter
index —— Specify the protocol group ID.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Add Gigabit Ethernet port 20 to protocol group 1:
T2500G-10TS(config)#interface gigabitEthernet 1/0/20
T2500G-10TS(config-if)#protocol-vlan group 1
5.4 show protocol-vlan template
Description
The show protocol-vlan template command is used to display the
information of the Protocol-based VLAN templates.
Syntax
show protocol-vlan template
Command Mode
Privileged EXEC Mode and Any Configuration Mode
42