TP-Link T2500G-10TS - Ipv6 Mld Snooping Vlan Static; Ipv6 Mld Snooping Querier Vlan

32.15 ipv6 mld snooping vlan static
Description
The ipv6 mld snooping vlan static command is used to configure the static
multicast groups. To disable the static multicast group, please use no ipv6
mld snooping vlan static command.
Syntax
ipv6 mld snooping vlan vlan-id static ipv6_multicast_addr interface
gigabitEthernet
port
no ipv6 mld snooping vlan
vlan-id static ipv6_multicast_addr [interface
gigabitEthernet
port ]
Parameter
vlan-id —— The multicast group VLAN ID, ranging from 1 to 4094.
ipv6_multicast_addr —— IPv6 address of the static multicast group.
port —— Interface number of the member port(s).
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the static multicast group ff80::1234 in VLAN 2 with the member
port gigabitEthernet 1/0/2:
T2500G-10TS(config)# ipv6 mld snooping vlan 2 static ff80::1234 interface
gigabitEthernet 1/0/2
32.16 ipv6 mld snooping querier vlan
Description
The ipv6 mld snooping querier vlan command is used to enable the MLD
Querier function. To disable this function, please use no ipv6 mld snooping
querier vlan command.
Syntax
ipv6 mld snooping querier vlan vlan-id
no ipv6 mld snooping querier vlan vlan-id
276