TP-Link T2500G-10TS - Hostname; Location

Example
Specify the DST start time of the switch as 2:00 am on the first Sunday in May,
the end time as 2:00 am on the last Sunday in October and the offset as 45
minutes:
T2500G-10TS(config)# system-time dst recurring first Sun May 02:00 last
Sun Oct 02:00 45
21.6 hostname
Description
The hostname command is used to configure the system name. To clear the
system name information, please use no hostname command.
Syntax
hostname [ hostname ]
no hostname
Parameter
hostname —— System Name. The length of the name ranges from 1 to 32
characters. By default, it is the device name, for example “T2500G-10TS”.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the system name as TPLINK:
T2500G-10TS(config)# hostname TPLINK
21.7 location
Description
The location command is used to configure the system location. To clear the
system location information, please use no location command.
Syntax
location [ location ]
no location
158