TP-Link T2500G-10TS - Switchport Dot1 Q-Tunnel Missdrop; Switchport Dot1 Q-Tunnel Mode

6.5 switchport dot1q-tunnel missdrop
Description
The switchport dot1q-tunnel missdrop command is used to enable the
VLAN-VPN missdrop function for a specific port. To disable the VLAN-VPN
missdrop function, please use the no switchport dot1q-tunnel missdrop
command.
Syntax
switchport dot1q-tunnel missdrop
no switchport dot1q-tunnel missdrop
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the VLAN-VPN missdrop function for Gigabit Ethernet port 1/0/3:
T2500G-10TS (config)#interface gigabitEthernet 1/0/3
T2500G-10TS (config-if)#switchport dot1q-tunnel missdrop
6.6 switchport dot1q-tunnel mode
Description
The switchport dot1q-tunnel mode command is used to configure the VPN
port’s mode. To close this VPN port, please use the no switchport
dot1q-tunnel mode command. By default, no port has been configured as
the VPN port. The VPN port mode uni and nni cannot switch to each other
directly, so please close the VPN port and switch to the other mode if
needed.
Syntax
switchport dot1q-tunnel mode { uni/nni }
no switchport dot1q-tunnel mode
47