TP-Link T2500G-10TS - Ipv6 Mld Snooping Multicast-Vlan Vlan-ID; Ipv6 Mld Snooping Vlan

32.9 ipv6 mld snooping multicast-vlan vlan-id
Description
The ipv6 mld snooping multicast-vlan vlan-id command is used to specify
the multicast VLAN ID. The default multicast VLAN is VLAN1. To restore the
default VLAN, please use no ipv6 mld snooping multicast-vlan vlan-id
command.
Syntax
ipv6 mld snooping multicast-vlan vlan-id vid
no ipv6 mld snooping multicast-vlan vlan-id
Parameter
vid —— The specified IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify multicast VLAN as VLAN 2:
T2500G-10TS(config)# ipv6 mld snooping multicast-vlan vlan-id 2
32.10 ipv6 mld snooping vlan
Description
The ipv6 mld snooping vlan command is used to enable MLD Snooping
function on a specified VLAN. To disable it, please use no ipv6 mld snooping
vlan command.
Syntax
ipv6 mld snooping vlan vlan-id
no ipv6 mld snooping vlan
vlan-id
Parameter
vlan-id ——The specified VLAN ID to enable MLD Snooping function, ranging
from 1 to 4094.
272