TP-Link T2500G-10TS - Dldp Shut-Mode

Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify the interval of sending advertisement packets as 10 seconds:
T2500G-10TS(config)# dldp interval 10
30.3 dldp shut-mode
Description
The dldp shut-mode command is used to configure the shutdown mode
when a unidirectional link is detected.
Syntax
dldp shut-mode { auto | manual }
Parameter
auto —— The switch automatically shuts down ports when a unidirectional
link is detected. By default, the shut-mode is auto .
manual ——The switch displays an alert when a unidirectional link is detected.
The operation to shut down the unidirectional link ports is accomplished by
the users.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the shut-mode as manual:
T2500G-10TS(config)# dldp shut-mode manual
245