Weather Pack Terminal Release Tool
Ventrac Part No. 72.0030
The weather pack terminal release tool
depresses the terminal release barbs
allowing weather pack terminals to be
removed from the connectors. The
weather pack terminal release tool is a
component of the Dealer Toolkit part
no. 70.0121.
Metri Pack Terminal Release Tool
Ventrac Part No. 72.0029
The metri pack terminal release tool
disengages the male terminal from the
female housing. The metri pack terminal
release tool is a component of the
Dealer Toolkit part no. 70.0121.
DC Amp Shunt Tool
Ventrac Part No. 72.0015
The DC Amp shunt tool allows the
technician to check for system draw with
the key switch off, system draw with the
key switch on, starter peak amp and
steady amp draw, and alternator
charging.
Weather Pack / Metri Pack Wire Crimper Tool
Ventrac Part No. 72.0027
The Weather Pack / Metri Pack wire
crimper tool allows technicians to
properly install Weather Pack and Metri
Pack terminals.
Deutsch Wire Crimper Tool
Ventrac Part No. 72.0028
The Deutsch crimper tool allows
technicians to properly install Deutsch
terminals.
Specifications: Special Tools Page 2–20 4520P
09.40003Rev 00
To Next Page
Loading...
