Xerox WorkCentre 5230 User Manual

February, 2008
6-136
WorkCentre 5225, 5230
Test Pattern Print
Launch Version
General Procedures
• If IOT Built-in PG is specified, 2 Sided (Dup) is prohibited when specifying MPT.
(*1):Length is longer than A4 length and breadth is longer than Letter breadth.
(*2): Displays 294mmx17inch (A3 breadth x Ledger length) (means that A3 and Ledger are
both supported sizes)
(*3):Refer to the specifications described in Detection.
Table 3 Pattern Overview
No. Pattern Name Objective / Overview
Built-in Image
Sub
051 Paper Feed Alignment Adjust-
ment pattern (Grid Pattern)
For IOT Regi Adjustment
20mm interval/line spacing 0.2 +/-
0.025mm
Controller
052 Total Chart For adjustment and isolating the
problem
Controller
Table 4 Parameter settings available for pattern output
No. Name
Image
Size
Tray
Paper
Sizes when
using MPT
Paper
Types
when using
MPT
Simp/
Dup
051 Paper Feed Alignment Adjustment
pattern (Grid Pattern)
Controller generated
1 (*1) (*3) A4 or Letter
LEF
-
052 Total Chart 1 (*2) (*3) A3 or
11"x17”
-
Table 5 IIT Pattern Overview
No. Pattern Name Tray
Paper
Sizes when
using MPT
Paper
Types
when using
MPT
Simp/Dup
- IIT Fast Scan Ink Gradation Tray 1:1
Tray 2:2
Tray: 33
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- IIT Slow Scan Ink Gradation Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- Shading Data Output Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- 1 dot-wide grid Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- 2dot-wide grid Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- 4dot-wide grid Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- Fast Scan 256 Gradation Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup
- Slow Scan 256 Gradation Tray 1:1
Tray 2:2
Tray 3:3
Tray 4:4
MPT:5
A3SEF Plain Simp/Dup

Xerox WorkCentre 5230 Specifications

General

Maximum print size	A3 (297 x 420 mm)
Standard input capacity	500 sheets
Internal memory	No MB
Type	Digital copier