EasyManua.ls Logo

Xerox WorkCentre 5230

Xerox WorkCentre 5230
1457 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
February, 2008
2-261
WorkCentre 5225, 5230
018-400, 018-500
Status Indicator Raps
Launch Version
018-400 IPSEC Error (Configuration Mismatch) RAP
While IPSEC is set to Enable, password is not set in authentication mode= [Pre-shared key] or
IPSEC certificate is not set in authentication mode= [Digital signature].
Procedure
Make IPSEC setting consistent and enable IPSEC again. Inconsistency in IPSEC setting: Pass-
word is not set with Authentication mode= [Pre-shared Key] or Authentication mode= IPSEC certifi-
cate is not set with [Digital signature]. To set these items which are not set.
018-500 CA Message Receiver Boot Error (S_cert lost)
RAP
Job cannot be executed with designated combination of parameters (storage file size, paper size,
paper tray, Duplex designation, output tray).
Procedure
Re-set paper size, paper tray, Duplex designation and output tray etc. and retry job.

Table of Contents

Other manuals for Xerox WorkCentre 5230

Related product manuals