February, 2008
4-177
WorkCentre 5225, 5230
REP 22.3.1, REP 22.3.2
Repairs and Adjustments
Launch Version
10. Remove the Paddle Belt. (Figure 8)
(1)Remove E-Clips (2).
(2)Move Bearings (2) in the direction of the arrows.
(3)Remove Sub Paddle Shaft Assembly.
(4)Remove Paddle Belt.
Figure 8 Removing the Paddle Belt (j0fa42208)
Replacement
1. Reverse the removal procedure for replacement.
2. Install the Paddle Link Assembly as shown in the figure. (Figure 9)
Figure 9 Installing the Paddle Link Assembly (j0fa42209)
REP 22.3.2 Sub Paddle Solenoid
Parts List on PL 22.3
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine. (REP 22.1)
2. Remove the Inner Front Cover. (PL 22.1)
3. Turn over the A-Finisher.
4. Remove the Bottom Cover. (PL 22.2)
5. Disconnect the Connector. (Figure 1)
(1)Release Clamps (3) and remove the wires.
(2)Disconnect Connector.
Figure 1 Disconnecting the Connector (j0fa42210)
6. Turn over the A-Finisher.
Paddle Link Assembly
To Next Page
Loading...
Need help?
General
