EasyManuals Logo

Xerox WorkCentre 5230 User Manual

Xerox WorkCentre 5230
1457 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #642 background imageLoading...
Page #642 background image
February, 2008
2-619
WorkCentre 5225, 5230
116-388, 116-389
Status Indicator Raps
Launch Version
116-388 MCC RAP
The control logic detected that the HDD is not installed during an MCC operation (Mail Contents
Creator).
Initial Actions
Power Off/On
Procedure
Check the electrical connections on the HDD (PL 9.2).
If the problem persists perform Hard Disk Diagnostic Program.
If the problem persists replace the HDD (PL 9.2).
116-389 RAM Install RAP
The control logic detected that the required RAM capacity is not installed or available.
Initial Actions
Power Off/On
Procedure
Reinstall or replace the DIMM (PL 9.2).
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists, replace the ESS PWB (PL 9.2).

Table of Contents

Other manuals for Xerox WorkCentre 5230

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 5230 and is the answer not in the manual?

Xerox WorkCentre 5230 Specifications

General IconGeneral
Maximum print sizeA3 (297 x 420 mm)
Standard input capacity500 sheets
Internal memoryNo MB
TypeDigital copier

Related product manuals