February, 2008
2-57
WorkCentre 5225, 5230
005-123
Status Indicator Raps
Launch Version
005-123 CVT Simplex/Side1 Registration JAM RAP
After pre-registration started (DADF Feed Motor On (CCW)), the Registration Sensor did not
turn On within the specified time.
Initial Actions
• Refer to BSD 5.4/5.5.
Procedure
Execute Component Control[005-110]. Actuate the DADF Registration Sensor (PL 15.7) with
paper.
The display changes.
YN
Check the connections of P/J782 and P/J761. P/J782 and P/J761 are connected cor-
rectly.
YN
Connect P/J782 and P/J761.
Check the wire between /J782 and J761 for an open circuit or a short circuit (BSD 5.4
Flag 1/Flag 2).
The wire between /J782 and J761 is conducting without an open cir-
cuit or a short circuit.
YN
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P761-15 (+) and GND (-) (BSD 5.4Flag 2).
The voltage is approx. +5VDC.
YN
Replace the DADF PWB (PL 15.3).
Measure the voltage between the DADF PWB P761-14 (+) and GND (-) (BSD 5.4 Flag 1).
Actuate the DADF Registration Sensor with paper. The voltage changes.
YN
Replace the DADF Registration Sensor (PL 15.7).
Replace the DADF PWB (PL 15.3).
Execute Component Control[005-001]. The DADF Feed Motor (PL 15.9) starts up.
YN
Check the connections of P/J764 and P/J754. P/J764 and P/J754 are connected cor-
rectly.
YN
Connect P/J764 and P/J754.
Check the wire between J764 and J754 for an open circuit or a short circuit (BSD 5.5 Flag
1).
The wire between J764 and J754 is conducting without an open circuit or a short
circuit.
YN
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB (PL 15.3) P754-1 (+) and GND (-), and
between P754-7 (+) and GND (-) (BSD 5.5 Flag 1).
The voltage is approx. +24VDC.
YN
Replace the DADF PWB (PL 15.3).
Replace the DADF Feed Motor (PL 15.9). If the problem persists, replace the DADF PWB
(PL 15.3).
Replace the DADF PWB (PL 15.3).
A
A
B
B
To Next Page
Loading...
Need help?
General
