YASKAWA V1000 Technical Manual

Start-Up Programming & Operation
This chapter explains the functions of the LED operator and how to program the drive for initial
operation.
4.1 SECTION SAFETY............................................................................................76
4.2 USING THE DIGITAL LED OPERATOR..........................................................78
4.3 THE DRIVE AND PROGRAMMING MODES....................................................82
4.4 START-UP FLOWCHARTS..............................................................................88
4.5
POWERING UP THE DRIVE.............................................................................93
4.6 APPLICATION SELECTION.............................................................................94
4.7 AUTO-TUNING................................................................................................100
4.8 NO-LOAD OPERATION TEST RUN...............................................................106
4.9 TEST RUN WITH LOAD CONNECTED..........................................................107
4.10 VERIFYING PARAMETER SETTINGS AND BACKING UP CHANGES.......108
4.11 TEST RUN CHECKLIST.................................................................................110
4
YASKAWA ELECTRIC SIEP C710606 16C YASKAWA AC Drive – V1000 Technical Manual
75

YASKAWA V1000 Specifications

General

Input Voltage	3-Phase 200-240VAC, 3-Phase 380-480VAC
Output Voltage	3-Phase 200-240VAC, 3-Phase 380-480VAC
Output Frequency	0-400 Hz
Control Method	V/f control
Overload Capacity	150% for 60 seconds
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Options	Modbus RTU
Ambient Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20°C to +65°C (-4°F to 149°F)
Humidity	95% (non-condensing)
Cooling Method	Forced Air Cooling
Enclosure	IP20