YOKOGAWA ADMAG TI Series

<5. Functions>
108
IM 01E21A02-03EN
 Alarm record mask
Ifthealarmrecordmaskfunctionisturned“On”,itdisablesthealarmrecord.
Settingexampleforalarm“Emptypipedetection”:
 Todisablethealarmrecord,set“Emptydetecton”ofSTB:AlarmRecordMask2to“On”.
 Toenablethealarmrecord,set“Emptydetecton”ofSTB:AlarmRecordMask2to“O󰀨”.
Menu path
Display Devicesetup►Diag/Service►Sts/Selftest►Alarm►Alarmrecordmask►(seebelow)
F
OUNDATION
Fieldbus
DeviceConguration►STB►DeviceConguration►QueryDevice►SnsrTBOriginal
Parameters(Part2)►Page4►AlarmRecordMask►(seebelow)
Block
Name
Relative
Index
Parameter
Description
Display F
OUNDATION Fieldbus
STB 152
Mask 1-1
Alarm Record Mask1
Speciesthemaskfunctionfor
alarm record 1-1.
Mask 1-2
Speciesthemaskfunctionfor
alarm record 1-2.
STB 153
Mask 2-1
Alarm Record Mask2
Speciesthemaskfunctionfor
alarm record 2-1.
Mask 2-2
Speciesthemaskfunctionfor
alarm record 2-2.
STB 154 Mask 3-1 Alarm Record Mask3
Speciesthemaskfunctionfor
alarm record 3-1.
NOTE
Notethatanalarmmaskedwiththealarmnoticationmaskfunctionisnotrecordedinthealarm
record.
The alarm mask function setting is as follows.
Parameter Name Indicates the name of the mask setting parameter.
Alarm Name Indicates the alarm name.
Default Value
Indicatesthedefaultsettingvalues(atshipmentfromthemanufacturingfactory).(:
Masked,-:Notmasked)
Attribute
Indicateswhetherthemasksettingisenabledordisabled.(: Setting enabled, -: Setting
disabled)
 Alarmnoticationmaskfunction
Display FOUNDATION Fieldbus
Default Value Attribute
Parameter
Name
Alarm Name
Parameter
Name
Alarm Name
- 010:Main CPU FAIL -
Main board CPU
failure
- -
- 011:Rev calc FAIL -
Reverse calculation
failure
- -
- 012:Main EEP FAIL -
Main board EEPROM
failure
- -
Mask 1-1 013:MainEEPdt Alarm out mask 1
Main board EEPROM
default
-

- 014:Snsr bd FAIL - Sensor board failure - -
- 015:Snsr comm ERR -
Sensor
communication error
- -
- 016:AD1FAIL[Sig] - A/D1failure[Signal] - -
- 017:AD2FAIL[Excit] - A/D2failure[Exciter] - -