YOKOGAWA ADMAG TI Series User Manual

<5. Functions>
122
IM 01E21A02-03EN
Thedefaultvalueof“Allblocktargetmode”andthevaluerightafter“Restore”is“Notexecute”.
Menupath(atthefollowingvepointsonthemenutreeofthedisplay)
Display
Devicesetup►Blockmode►(seebelow)
Devicesetup►Diag/Service►(seebelow)
Devicesetup►Easysetupwizard►(seebelow)
Devicesetup►Detailedsetup►(seebelow)
Devicesetup►Detailedsetup►Fieldbusinfo►(seebelow)
Block
Name
Relative
Index
Parameter
Description
Display F
OUNDATION Fieldbus
- -
All block target
mode
-
Switch the target mode of
RB/STB/DTB/LTB/MTB/FB
(AIFB,DIFB)atonce.
Select from the table below.
Selection
Description
Display
F
OUNDATION
Fieldbus
O/S -
Set the target mode of each block to O/S. If this value is written twice or
morebefore[Restore],O/Smodeisstoredinthetransmitter.
Restore Restore each block to the target mode before executing this function.
Not Execute Not execute
5.7.7 microSD Card Setting
If the optional code MC is selected, the backup parameters and logging data can be used by
inserting the dedicated microSD card into the display.
For details about backing up parameters and logging data, refer to Section 5.11.
(1) Removing the microSD card
IMPORTANT
If“Unmount”isnotexecutedonthesoftwarewhenremovingthemicroSDcard,itmaycause
data stored on the microSD card to be erased or the device to operate abnormally.
The microSD card can be removed with the following parameter.
Menu path
Display Devicesetup►microSD►(seebelow)
Parameter Description
Unmount SpeciestheremovalofthemicroSDcard.
From the table below, select whether to remove the microSD card.
Selection Description
Cancel Cancels the removal of the microSD card.
Execute Makes it possible to remove the microSD card in safety.

YOKOGAWA ADMAG TI Series Specifications

General

Brand	YOKOGAWA
Model	ADMAG TI Series
Category	Measuring Instruments
Language	English