YOKOGAWA ADMAG TI Series User Manual

<5. Functions>
78
IM 01E21A02-03EN
Display --
F
OUNDATION
Fieldbus
DeviceConguration►DTB►DeviceConguration►Conguration►LimitSwitch
Conductivity2►(seebelow)
Block
Name
Relative
Index
Parameter
Description
Display F
OUNDATION Fieldbus
DTB 103
--
Lim.Sw. Conductivity 2 Value
►LmtStsCndc2.Status
Displays the status of the contact point
output of conductivity limit switch 2.
--
Lim.Sw. Conductivity 2 Value
►LmtStsCndc2.Value
Displays the contact point output of
conductivity limit switch 2.
DTB 104 -- Lmt Sts Cndc2 Sp
Speciesthethresholdofconductivity
limit switch 2.
DTB 105 -- Lmt Sts Cndc2 Act Dir
Speciestheoperationdirectionof
conductivity limit switch 2.
DTB 106 -- Lmt Sts Cndc2 Hys
Speciesthehysteresisofconductivity
limit switch 2.
DTB 107 -- Lmt Sts Cndc2 Unit Displays the unit of the conductivity.
The following selections are available as an operation method.
Selection
Description
Display
F
OUNDATION
Fieldbus
-- state 0 Limitstatusisnotactivated(conditionsarenotmet)
-- state 1 Limitstatusisactivated(conditionsaremet)
The following selections are available as an operation direction.
Selection
Description
Display
F
OUNDATION
Fieldbus
-- Low limit Does not use the reset/preset function of the totalized value.
-- High limit Uses the reset function of the totalized value.

YOKOGAWA ADMAG TI Series Specifications

General

Brand	YOKOGAWA
Model	ADMAG TI Series
Category	Measuring Instruments
Language	English