Zebra ZD620 - WIRED IP PROTOCOL

108
Printer Configuration Menus
WIRED IP PROTOCOL
Description: This parameter indicates if the Net Administrator/User (permanent) or the
server (dynamic) selects the Wired print server’s IP address. When a dynamic option is
chosen, this parameter tells the method(s) by which this print server receives the IP
address from the server.
Important • The print server must be reset to allow changes to the network settings to take effect.
Accepted values:
• ALL
• GLEANINGONLY
• RARP
• BOOTP
• DHCP
• DHCP&BOOTP
• PERMANENT
Related ZPL command(s): ^ND
SGD command used: internal_wired.ip.protocol
Printer Web page: ViewandModifyPrinterSettings>Network Communications
Setup>TCP/IP Settings
NETWORK
—
ACTIVE PRINT SERVER
—
PRIMARY NETWORK
—
WIRED IP ADDRESS
—
WIRED SUBNET MASK
—
WIRED GATEWAY
—
WIRED IP PROTOCOL
—
WIRED MAC ADDRESS
—
WLAN IP ADDRESS
—
WLAN SUBNET MASK
—
WLAN GATEWAY
—
WLAN IP PROTOCOL
—
WLAN MAC ADDRESS
—
ESSID
—
CHANNEL
—
SIGNAL
—
IP PORT
—
IP ALTERNATE PORT
—
PRINT INFORMATION
—
RESET NETWORK
—
VISIBILITY AGENT
—
LOAD DEFAULTS